Eddyfi Ectane 2 Guide de l'utilisateur télécharger pdf (Page 51)

Chapter 6: Maintenance & Troubleshooting Preventive Maintenance

Preventive Maintenance

Due to its design, the Ectane

2 only requires minimal maintenance.

Because it has no moving parts, the Ectane 2 also does not require any preventive

maintenance by the user. Only a regular inspection of the instrument is

recommended, to ensure that it is properly grounded.

Also, Eddyfi strongly recommends an annual calibration and a factory-performed

preventive maintenance by an officially qualified Eddyfi technician.

Cleaning the Instrument

The Ectane 2 external surfaces (i.e., casing and front panel), can be cleaned when

necessary. This section explains the procedure to appropriately clean the

instrument.

To clean the instrument:

1. Make sure that the instrument is off and that the power cord is disconnected.

2. To bring the instrument back to its original finish, clean the casing and the

front panel with a soft cloth.

To removed stubborn stains, use a cloth moistened with soft soapy solution. Do not

use abrasive products or powerful solvents as they can damage the finish.

Wait until the instrument is completely dry before connecting the power cord and

cables.

WARNING!

Do not clean the instrument with a spray or water jet.

If you do, connector contacts can remain wet and produce short circuits when

connected.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 57 58

Pas de commentaire

Eddyfi Ectane 2 Guide de l'utilisateur Page 51